Adjustable Faux Leather Body Harness with Choker

This black faux leather body harness pairs a structured wide waist belt with two shoulder straps that converge at silver D-ring connectors across the chest, giving a sharp silhouette over any base layer. The set includes a matching studded choker with the same black faux leather and silver-toned metal studs for a coordinated look without extra effort.

Shoulder Straps and Waist Belt

The shoulder straps run parallel from the choker area down to a wide waist belt approximately 4 cm in height, secured with a classic silver-tone pin buckle. Each strap features a D-ring connection point at the chest, letting you adjust tension independently on each side.

• Shoulder strap width: approximately 2 cm, padded with a smooth inner surface
• Waist belt height: approximately 4 cm with a single-pin silver buckle
• D-ring connectors at chest in silver-toned metal
• All straps fully adjustable with sliding keepers
• Choker width approximately 1.5 cm with evenly spaced metal studs

Styling and Occasion

Worn over a fitted bodysuit or a simple crop top, the harness adds a structured layer that reads as an accessory rather than outerwear. The all-black palette keeps it versatile for both daytime editorial looks and evening outfit builds.

• Layer over a black mesh top and high-waist trousers for a club-ready look
• Pair with a white shirt left open at the front for a street-style contrast
• Wear over a bodysuit and mini skirt for a festival or concert outfit
• Works as a standalone layering piece over turtleneck knits in cooler months

Sizing and Fit

The harness is designed for a waist range of approximately 60-90 cm; the shoulder straps extend to fit a torso length of roughly 40-55 cm from shoulder to waist. It sits comfortably on sizes XS through L. The buckle system means the fit is dialed in precisely rather than relying on fixed holes, so there is no single-position snap fit — this design does not suit very short torsos under 38 cm as the straps may bunch near the waist belt.

Material and Care

The straps and belt are cut from faux leather (PU-coated woven base) with a smooth matte finish that resists minor scuffs. Hardware is silver-toned zinc alloy. Because the material is PU-coated, it should not be machine washed — wipe with a damp cloth, then allow to air dry flat. Avoid prolonged exposure to direct sunlight, which can cause the PU surface to dull and crack over time.

• Outer: PU faux leather, smooth matte finish
• Hardware: zinc alloy, silver-toned, non-tarnish coating
• Care: wipe clean only — no machine wash, no tumble dry
• Store flat or loosely rolled to prevent crease marks