Adjustable Faux Leather Body Harness with O-Ring

This black faux leather body harness runs two thin shoulder straps down to a single central O-ring at the chest, then connects to a wide adjustable waist band — giving the structured cage look without bulk. The straps measure approximately 1 cm wide and the waist band sits roughly 3 cm wide, so the silhouette stays visible over layered knitwear or fitted tops.

Styling Over Everyday Outfits

The narrow black straps read as a graphic layer rather than outerwear, which means they work over a wide range of basics. Try it over a fitted gray marl knit dress for a street-ready contrast, or wear it directly over a white fitted shirt to break up a monochrome look. Two concrete combinations that photograph well:

• Over a long-sleeve bodycon dress — the vertical chest strap line lengthens the torso visually
• Over a plain cropped t-shirt and high-waist trousers — the waist band emphasizes the waist-to-hip ratio
• Over a sheer blouse at a party — silver hardware catches venue lighting without added jewelry

Adjustable Fit and Sizing

Every strap runs through a silver-tone buckle closure, so the chest section and waist band adjust independently. The waist band fits approximately 60 cm to 90 cm at the natural waist, covering most standard EU sizes 34-42. The shoulder-to-waist length is fixed at roughly 38 cm — this works best on torso lengths between 38 cm and 48 cm. Very petite frames may find the O-ring sits lower than chest level; very tall frames may need to tighten the shoulder straps to their minimum to center the ring.

• Waist band adjustable range: approximately 60-90 cm
• Strap width: 1 cm shoulder straps, 3 cm waist band
• Best fit for torso length 38-48 cm (shoulder to natural waist)
• Studs along the waist band add 3 mm of fixed thickness — note if worn under tight-fitting outerwear

Faux Leather Material and Care

The straps and waist band are cut from PU faux leather with a smooth matte finish — the surface looks structured under studio light without the stiffness of genuine leather. The hardware is silver-tone zinc alloy (not solid silver, so avoid prolonged moisture contact to prevent tarnish). To clean, wipe with a slightly damp cloth and dry flat away from direct heat; do not machine wash, do not soak, and do not tumble dry, as sustained water exposure can cause PU coating to peel at the edges over time.

• Material: PU faux leather straps and waist band
• Hardware: silver-tone zinc alloy buckles and O-ring
• Care: wipe clean only — no machine wash, no soaking
• Trade-off: PU edges may show wear at buckle contact points after heavy daily use

Wearing as a Fashion Accessory

Because the harness layers over clothing rather than replacing it, it functions as a fashion accessory with a wide range of daily use scenarios — from weekend brunch over a dress to a club night over a sheer top. The adjustable design means one size covers a broad range without needing separate size variants, which is practical for gifting. The single O-ring at the center chest is the focal point; keeping necklaces minimal avoids competing with it visually.