Adjustable Faux Leather Full Body Harness with O-Rings

This black faux leather full body harness features narrow 1.5 cm straps that cross over the chest, frame the torso, and anchor at the waist with two individual side buckles — all finished with silver-tone O-rings and stud rivets. Unlike simpler chest-only designs, the harness spans from shoulder to hip, creating a structured cage silhouette that works as a standalone statement or a layering piece over mesh and sheer fabrics.

Strap Layout and Hardware

The strap configuration runs two parallel bands across the upper chest, converging at a central silver O-ring positioned at the sternum. From there, two vertical straps descend to a second horizontal band at the mid-torso, which connects to a lower waist strap via riveted D-ring junctions. All metal hardware is silver-tone with a brushed finish; the buckles are standard pin-bar style, approximately 2.5 cm wide. The rivets are decorative rather than structural, adding a minimal industrial texture to each connection point.

• Central chest O-ring, approximately 4 cm diameter, silver-tone
• Two pin-bar waist buckles, each adjustable across a 10 cm range
• Flat 1.5 cm strap width throughout — proportional on sizes XS to L
• Six visible stud rivets at strap junctions for a clean industrial detail
• Lightweight construction — full harness weighs under 150 g

How to Style for Different Occasions

Worn over a black mesh long-sleeve bodysuit (as shown), the harness reads as a high-fashion layering piece for festival or club styling. For a more subtle daytime edge, pair it over a fitted white or nude crop top — the black straps read as a graphic belt-and-suspender hybrid rather than lingerie. A third option: layer it over an oversized blazer with the straps visible at the neckline for an editorial street-style look. The waist straps sit low enough to work with high-waisted trousers or skirts without bunching.

• Festival outfit: over sheer mesh bodysuit + high-waisted shorts
• Street style: over oversized blazer, waist straps as belt accent
• Lingerie styling: worn alone as the primary garment over bare skin

Sizing and Fit

The shoulder straps are not individually adjustable; fit depends on torso length and chest circumference. The harness fits most torso lengths between 40 cm and 55 cm (measured from shoulder to natural waist). The waist buckles allow the lower band to sit anywhere from 65 cm to 80 cm circumference. The chest band spans roughly 70 cm to 90 cm. This means it fits well on UK/EU sizes 36–42 (approx. S to L); it is not recommended for bust circumferences above 100 cm as the center O-ring placement shifts and the silhouette changes significantly. Petite frames under 160 cm height may find the torso straps slightly long.

Material and Care

The straps are cut from smooth-grain faux leather (PU coated polyurethane) with no lining on the inner face — the back of each strap is the base fabric layer. PU faux leather resists minor moisture and surface scuffs better than PVC alternatives but is not waterproof. Do not machine wash or submerge in water; wipe clean with a slightly damp cloth and allow to air dry flat. Avoid folding the straps at sharp angles during storage, as repeated creasing at the same point can cause the PU coating to crack over time. Hardware is zinc alloy with a silver electroplate — keep away from prolonged humidity to prevent tarnish.