Asymmetric Faux Leather Body Harness with O-Ring Waist

This black faux leather body harness crosses one shoulder diagonally and cinches at the waist with a centered silver-tone O-ring, creating an asymmetric silhouette that works as a standalone accessory over any top. Unlike symmetric cage-style designs, the single-strap construction keeps the look graphic but minimal — one shoulder stays fully bare.

Street Style Outfit Pairings

The harness reads most clearly layered over fitted basics that let the strap geometry show. Two proven combinations:

• Black crop top + high-waist blue jeans + chunky white sneakers — the look seen on the model, daytime-ready
• White ribbed tank tucked into wide-leg trousers + ankle boots — the black strap against white creates a sharp graphic contrast
• Oversized graphic tee + biker shorts — the waist band pulls the look in and adds structure to a relaxed silhouette

Adjustable Strap Construction

The shoulder strap and waist band each fasten with silver-tone pin buckles, allowing the fit to be dialed in rather than sized by S/M/L alone. Small eyelet rows along the strap give approximately 8 cm of adjustment range per buckle. The O-ring at the waist center is a fixed decorative ring, not load-bearing — it is cosmetic hardware, which is the honest trade-off versus a structural harness.

• Single diagonal shoulder strap with pin-buckle closure
• Waist band width approximately 2.5 cm
• O-ring diameter approximately 4 cm, silver-tone metal
• Eyelet reinforcements along strap edges for durability

Sizing and Fit Notes

The waist band fits most torso circumferences between 62 cm and 88 cm when both buckles are used. The shoulder strap length suits bust heights from approximately 30 cm to 42 cm measured from shoulder to waist. Very long torsos may find the strap sits too short at the buckle's maximum extension — check the waist-to-shoulder measurement before ordering. The design is cut for a fitted, not loose, appearance.

Faux Leather Care

The straps are made from PU faux leather over a fabric backing — the same construction used across most vegan leather accessories in this price range. Wipe clean with a damp cloth; do not submerge in water or machine wash. Store flat or hanging to prevent crease lines in the PU coating. Avoid prolonged exposure to direct sunlight, which can fade the matte black finish over time. The metal hardware is zinc alloy with a silver-tone plating — keep dry to prevent tarnishing.