Black Faux Leather Harness with Double O-Ring Detail

This chest harness is built around a dual O-ring architecture — one gunmetal ring sits at the upper back center, a second anchors the waist band below, creating a structured vertical spine between two horizontal straps. Unlike single-ring designs, the twin hardware points give the back view a layered, geometric silhouette that reads clearly over or under clothing.

Straps and Hardware Construction

The harness uses approximately 1.5 cm wide matte black faux leather bands — narrow enough to stay flat under a sheer blouse, wide enough to hold position without rolling. Silver-tone rivets reinforce every strap junction, and the waist band fastens with adjustable side ties that accommodate a range of torso widths. The two gunmetal O-rings are smooth-finish metal, not painted plastic, so they keep their finish with regular wear.

• Two gunmetal O-rings at upper-back and waist-back anchor points
• Strap width approximately 1.5 cm — sits flat under layered outfits
• Silver rivet hardware at every junction point for structural hold
• Adjustable side-tie waist band for a custom fit across different torso sizes
• Matte faux leather surface — no shine-through under flash photography

Styling and Occasion Ideas

Worn over a fitted white or cream turtleneck, the black straps and double O-rings show cleanly against light fabric — a straightforward way to add edge to a minimal base. For a layered festival or concert look, pair it over a black mesh top so only the hardware and O-rings stand out. The waist-level band also works as a standalone waist accessory over a high-waisted skirt, separating the chest harness from the lower strap for a more casual application. Not recommended for formal office settings — best suited to creative, nightlife, or festival environments.

Sizing and Fit Notes

The side-tie closure on the waist band adjusts to fit torso circumferences roughly between 60 cm and 85 cm at the underbust. The upper chest strap length is fixed, so the harness fits best on torsos with a bust circumference of 75-100 cm. If your bust-to-waist differential is more than 25 cm, the upper strap may sit slightly loose — this is a flat-strap design, not a molded bra-like structure, so some gap is normal and can be adjusted by layering or pinning. One size is available; the adjustable ties give moderate flexibility but do not stretch to very large frame proportions.

Material and Care

The straps are faux leather (vegan leather) over a woven fabric base, which keeps them pliable at room temperature but may stiffen in cold weather — allow a few minutes for the material to warm before adjusting the ties. The metal hardware is a silver-tone alloy with a gunmetal O-ring finish; avoid prolonged contact with water to prevent surface oxidation. Hand wash recommended: wipe the faux leather surface with a damp cloth and mild soap, do not submerge or machine wash. Air dry flat. Do not iron or tumble dry.

• Outer material: faux leather (vegan leather) over woven base
• Hardware: silver-tone alloy rivets, gunmetal O-rings
• Care: wipe clean with damp cloth, air dry — no machine washing
• Faux leather may stiffen slightly in temperatures below 10 degrees C