Büyük Beden Taba Kadın Deri Korse Kemer Askılı Vücut Aksesuarı

This tan faux leather waspie corset harness wraps the waist with a wide structured panel featuring dual front buckle straps, while matching shoulder straps connect up to a coordinating tie-detail choker — all in the same warm caramel-tan tone. Unlike a basic belt, the full-body connection from neck to hip creates a sculpted, corseted silhouette that works over everyday tops as well as going-out looks.

Styling for Everyday & Evening Outfits

Worn over a fitted white long-sleeve top and wide-leg trousers, this harness reads as polished street style rather than costume. The tan colorway pairs with neutrals, creams, and earth tones without clashing. For evening, layer it over a slip dress or blazer; the silver-tone O-ring hardware adds enough detail to replace a separate necklace. Because the choker and shoulder straps are fixed to the waist panel, you get a coordinated three-piece look with a single garment — no separate choker sizing needed.

Waist & Shoulder Fit Notes

The waspie panel is approximately 10 cm wide at the front and covers the natural waist and upper hip. Adjustable buckles on the front panel accommodate a range of roughly 60 cm to 85 cm waist circumference; buyers with a waist above 85 cm may find the shoulder strap length pulls short. The choker section has grommet-and-tie closure, fitting neck circumferences from about 30 cm to 40 cm. The shoulder straps are fixed-length, so torso height affects fit: a very long torso may find the straps sit closer to the neckline than the product image shows.

• Waspie panel width: approx. 10 cm at center front
• Waist adjustment range: 60 cm to 85 cm
• Choker fits neck circumference: 30 cm to 40 cm
• Shoulder straps are fixed length — best for average torso height
• Side panel wings extend to approx. 15 cm below the waist edge

Faux Leather Material & Care

The body is faux leather (PU-coated fabric) in a matte tan finish — smooth to the touch with minimal sheen, which keeps it looking like a fashion accessory rather than costume wear. Silver-tone metal O-rings and buckle hardware are riveted, not glued, for durability through regular wear. Because PU faux leather cannot be machine washed, spot-clean with a slightly damp cloth and mild soap; avoid soaking or wringing. Store flat or hung to prevent creasing at the panel fold. The lining is fabric-backed, which reduces direct skin irritation during extended wear.

• Body: PU faux leather, matte tan finish
• Hardware: riveted silver-tone metal O-rings and buckle clasps
• Lining: fabric backing on the inner waist panel
• Care: spot clean only — no machine wash, no soaking
• Trade-off: PU material will show crease marks if tightly folded during storage

How to Adjust the Buckles

Thread each front buckle strap through the metal frame and push the prong into the desired grommet hole. The choker ties at the back with two narrow faux leather laces — pull snug but not tight, as the PU does not stretch. Shoulder straps clip into O-rings on the waist panel; they are designed to sit straight over the collarbone when the waist panel is correctly positioned at the natural waist. For a relaxed daily look, leave one buckle strap unfastened; for a defined corset effect, fasten both.