Faux Leather Harness Bra & Waist Belt Set with Collar

This black faux leather harness bra and waist belt set is built around two structured pieces: a cage-style bra top with a wide under-bust band and a matching triple-strap waist belt. The padded collar sits roughly 3.5 cm wide and connects directly to the shoulder straps via gunmetal O-rings, keeping the entire upper piece integrated rather than floating. Unlike single-strap body harnesses, this set distributes weight across the chest band and collar for a more balanced fit.

Collar and Bra Strap Configuration

The collar piece is wide enough to rest flat against the neck without pressing uncomfortably, secured at the back with a buckle closure. Two angled shoulder straps descend from the collar through gunmetal D-rings and split to frame the structured bra cup area. Adjustable side buckles allow approximately 10 cm of sizing range on the shoulder straps. Flat silver-tone studs run along the bra band, adding a hardware detail that reads clearly even under an open jacket.

• Wide structured bra band, approximately 5 cm depth at center
• Padded collar with rear buckle closure, roughly 3.5 cm wide
• Gunmetal O-rings and D-rings at every strap junction
• Silver-tone rivets stud-punched into the bra band perimeter
• Shoulder straps adjustable by approximately 10 cm via side buckles

Waist Belt Strap Details

The waist belt piece features three horizontal parallel straps stacked between 3 cm and 4 cm apart, held at each side by a gunmetal D-ring and a single side-release buckle. Total waist coverage spans roughly 18 cm vertically, sitting from just below the natural waist to the top of the hip. The open spaces between straps are intentional — the design is meant to show skin rather than cover it, so this piece works over a high-waisted brief or as a standalone belt detail over bottoms.

• Three horizontal straps, each approximately 2 cm wide
• Vertical stack of straps covering roughly 18 cm at center front
• Single side-release buckle for quick on and off
• Matching gunmetal D-ring hardware consistent with the bra top

Sizing and Fit

The bra top is designed as a non-wired structured frame rather than a supportive bra. Cup area fits most A to C cup sizes comfortably; D cup and above may find the structured band too rigid to seat correctly. The collar fits neck circumferences from approximately 30 cm to 40 cm. The waist belt suits hip measurements from 68 cm to 98 cm using the buckle adjustment. This set runs true to a European S-L range — if you are between sizes, size up for the belt and size down for the bra top for the best simultaneous fit. One honest trade-off: the faux leather does not breathe, so extended wear in warm environments may feel warm at the collar and band.

Material and Care

Both pieces are constructed from smooth matte black faux leather (PU-coated fabric), which holds its shape without creasing as readily as bonded leather alternatives. Hardware is gunmetal-plated zinc alloy — durable for regular styling use but not salt-water resistant. Hand wash in cold water with a mild detergent, rinse gently, and hang to dry away from direct sunlight. Avoid machine washing and tumble drying, as heat degrades the PU coating. Wipe hardware dry immediately after any moisture contact to prevent tarnishing.

• PU faux leather exterior, smooth matte finish, no visible grain texture
• Gunmetal-plated zinc alloy hardware throughout both pieces
• Hand wash cold only; hang dry, no tumble drying
• Store flat or rolled to prevent permanent crease lines in the bra band