Full Body Harness Set with Adjustable Garter Straps

This two-piece black faux leather harness set pairs a crisscross torso harness with separate dual-band thigh garters, giving you layered coverage from shoulder to knee. The straps measure approximately 1.2 cm wide, thin enough to layer over a bodysuit or under a sheer top without bulking. Gold-toned O-ring connectors sit at the chest center, waist sides, and thigh band junctions — a detail that catches studio light without requiring any rhinestones or chains.

Torso Strap Configuration

The upper harness runs two shoulder straps down to a center chest O-ring, then fans out in an X pattern across the sternum before meeting a horizontal waist band. Adjustable side buckles on the waist section let you cinch or loosen the fit without removing the piece.

• Shoulder straps: adjustable sliders, approx. 35-55 cm total length range
• Chest X-cross: fixed geometry framing the collarbone and center front
• Waist band: circumference adjustable from approx. 60 cm to 90 cm via side buckles
• Hardware: gold-toned O-rings and pin buckles throughout

Thigh Garter Construction

The leg portion consists of two independent garter bands per thigh — one positioned at the upper thigh, one lower — connected by a short vertical strap with an O-ring at mid-point. Each band closes with its own pin buckle, so you can dial in fit independently for each leg.

• Upper thigh band fits approx. 45-65 cm circumference
• Lower band sits roughly 8-10 cm below the upper for a stacked look
• O-ring detail at vertical connector adds structural accent without extra weight
• Bands close independently — no need to synchronize both buckles at once
• Compatible with thigh-high stockings worn underneath

Sizing and Fit Notes

The torso harness adjusts to fit a bust circumference of roughly 75-100 cm and a waist of 60-90 cm. The thigh garters suit thigh circumferences up to approximately 65 cm per leg. If your thighs measure above 65 cm, the lower band may sit uncomfortably tight — size up or wear as a single-band style instead. The shoulder straps are not padded, so they can mark the skin after extended wear; plan for removal every 2-3 hours during events.

Material and Care

Straps are cut from vegan faux leather with a smooth matte finish — not patent, not textured croc. Hardware is zinc alloy with gold-tone plating. The material does not stretch, which keeps the geometric pattern crisp but means fit depends entirely on the buckle adjustments.

• Wipe clean with a damp cloth — do not submerge in water
• Store flat or coiled loosely to prevent crease marks in the faux leather
• Avoid prolonged contact with direct sunlight to preserve color depth
• Do not machine wash or tumble dry