Full Body Harness Set with Garter Straps & O-Rings

This two-piece black faux leather body harness set pairs a chest harness with a matching garter belt, connected by vertical straps that frame the torso. Approximately 1 cm wide flat faux leather straps run from a choker-style collar down to a center O-ring at the sternum, then split to wrap the waist and drop into four garter suspenders. Gold-tone metal O-rings and silver-tone stud rivets appear at every junction, keeping the geometry crisp wear after wear.

Chest & Garter Construction

The chest section forms a triangle bra cage that sits over any bra or directly on skin. Three O-rings anchor the horizontal band across the bust, the center sternum connector, and the side waist loops. The garter belt section crosses straps in an X pattern over the lower abdomen before dropping four adjustable suspender tabs — long enough to clip standard thigh-high stockings without extra extenders.

• Chest harness + garter belt: complete two-piece set
• Center front O-ring diameter approximately 3 cm, side O-rings approximately 2 cm
• Garter suspenders adjustable from approximately 18 cm to 30 cm drop length
• Gold-tone O-ring hardware with silver-tone rivet studs throughout
• Flat strap width approximately 1 cm — narrower than cage bras, sits flush against skin

Styling & Occasion Pairing

Worn over a sheer mesh bodysuit and wide-leg trousers, the chest harness reads as structured outerwear for a night-out look. Alternatively, layer the full set over a fitted midi slip dress — the garter straps visible below the hem add a deliberate lingerie-as-fashion detail. Because the straps are flat and matte black, they photograph cleanly against light or dark backgrounds, which makes this set practical for editorial shoots as well as personal styling.

• Over a sheer bodysuit with wide-leg trousers for a structured night-out outfit
• Layered over a slip dress, garter straps intentionally visible below hem
• As a standalone layer over high-waist briefs for a festival or themed event look

Sizing & Fit Guide

The chest harness fits a bust circumference of approximately 70 cm to 100 cm via the adjustable back and side buckles. The garter belt waist band stretches to fit hip measurements of approximately 80 cm to 105 cm. The design does not include underwire or structured cups, so it works as an overlay rather than a standalone bra — wearers who prefer lift will need to wear a bra underneath. Strap length cannot be shortened further than approximately 18 cm on the garter section, which may not suit very petite frames under 155 cm height.

Material & Care Notes

Straps are made from faux leather (PU) backed with a thin textile layer for flexibility. Hardware is zinc alloy with a gold-tone or silver-tone plating. Because the zinc alloy hardware is not waterproof, hand wash in cold water under 30 degrees Celsius, avoid soaking, and air dry flat away from direct heat. Do not tumble dry or iron. The faux leather surface can be wiped with a slightly damp cloth between full washes to keep it looking clean longer.