Full Body Harness with High Collar and Chest Cross Straps

This black faux leather full body harness pairs a structured high choker collar band with a geometric chest section built from two cross-shaped strap panels meeting at a central silver O-ring — a configuration that sets it apart from standard cage or O-ring harnesses. The design runs from neck to thigh in one continuous piece, covering the torso with horizontal waist and hip bands before transitioning into a lower cage section finished with dangling black tassel fringe on both sides.

Chest Cross Design and Collar Detail

The upper section starts with a wide collar band approximately 3 cm that sits high on the neck like a choker, secured at the back. Below it, two diagonal strap panels cross the chest in an X pattern and terminate in square cross-shaped cutouts over each side of the chest, connected at the center by a silver-tone O-ring. Silver dome stud rivets line every strap junction, giving the piece a structured, hardware-focused look suited to festival layering or statement outerwear styling.

• High choker collar band, approximately 3 cm wide
• Chest cross panels with square cutouts at each side
• Central silver O-ring connector at the chest
• Silver dome stud rivets at all major strap junctions
• Hanging black tassel fringe at the outer thigh, approximately 15 cm long

Sizing and Fit

The harness is designed to fit torso lengths from roughly 55 cm to 70 cm (collar base to hip), with each strap band adjustable via stud-and-loop closures at the back. The waist bands accommodate a circumference range of approximately 60-90 cm. The lower cage section uses adjustable hip straps rather than a fixed inseam, so it suits a wider range of hip widths. Note that the collar sits high on the neck — wearers with shorter necks may find it restrictive at the highest adjustment point. The piece is not designed to provide support or coverage on its own and is intended to be worn over a base layer or bodysuit.

• Torso length: adjustable for approximately 55-70 cm collar-to-hip range
• Waist bands: adjustable to approximately 60-90 cm circumference
• Back closures: stud-and-loop adjusters on each horizontal band
• Not designed for standalone coverage — best layered over a bodysuit or shorts

Material and Care

All straps are cut from faux leather (vegan leather PU) with a smooth matte surface that holds its shape without stiffening in cool temperatures. Hardware is silver-tone zinc alloy — it is decorative rather than load-bearing, so avoid hanging weight from the O-rings. To care for the piece, wipe with a damp cloth and mild soap, then air dry flat away from direct heat. Do not machine wash or submerge in water, as prolonged moisture can degrade the PU coating at the stud rivet points. Store flat or loosely rolled to prevent permanent creasing in the straps.

• Faux leather (PU vegan leather) strap material
• Silver-tone zinc alloy hardware — decorative, not load-bearing
• Clean with damp cloth and mild soap only
• Air dry flat, away from heat sources
• Store flat to prevent strap creasing

Styling and Occasions

Worn over a black mesh long-sleeve top and high-waisted shorts, the chest cross panels layer visibly through the mesh for a festival or concert look. Alternatively, pair the collar section alone over a fitted turtleneck bodysuit for a structured edge-fashion outfit without the full lower cage. The tassel fringe at the thigh swings with movement, adding a kinetic detail that reads well in motion. For rave or Halloween costume use, the full-piece silhouette photographs clearly against both dark and light backgrounds — the geometric strap layout shows up without requiring additional styling props. The all-black palette with silver hardware coordinates with most monochrome base layers.