Full Body Harness with O-Ring Detail

This black faux leather full body harness runs from the chest cage down to a triangular hip frame, connecting three zones with six silver-tone O-rings and flat 1.5 cm wide straps. Unlike single-zone chest harnesses, it creates a continuous structured silhouette from collarbone to upper thigh.

Chest Cage Construction

The upper section uses four horizontal straps that cross between the shoulders and sternum, forming a ladder-cage pattern. Each strap meets a central silver O-ring at the sternum, while two additional rings sit at the shoulder junction points. This multi-strap configuration distributes tension evenly so the harness stays flat against the body during movement.

• Four-strap chest cage sits flat without bunching on curvier frames
• Central sternum O-ring is a functional junction, not a decorative add-on
• Shoulder straps are individually adjustable for asymmetric torsos

Waist and Hip Frame

Below the ribcage, two O-rings at the natural waist anchor a wide horizontal band, then the design tapers into an inverted-triangle hip frame that rests at the upper thigh. The hip section includes one large central O-ring and a short chain link between the two lower side rings, adding subtle movement without requiring separate chain accessories.

• Waist band width approximately 2 cm for a visible but non-restrictive band
• Hip triangle frame sits at mid-thigh level on a 165 cm reference height
• Built-in 5 cm chain segment at the hip centerline
• All connecting points use riveted fastenings — no glue construction

Sizing and Fit

The harness is designed to fit bust circumferences of 80 cm to 110 cm and waist circumferences of 65 cm to 95 cm through multiple buckle adjustment points. The hip triangle adjusts at the side straps to fit hip measurements of 90 cm to 120 cm. Wearers taller than 175 cm may find the hip section sits slightly above the intended mid-thigh position; petite frames under 158 cm should size down or shorten the torso straps. The straps are not intended to bear body weight — this is a fashion overlay, not a suspension harness.

Material and Care

Straps are cut from faux leather with a smooth matte finish — no glossy coating that cracks at fold points. Hardware is zinc-alloy O-rings and buckles with a silver-tone plating. Because faux leather and zinc alloy are both moisture-sensitive, hand wash only in cold water with mild soap, then air dry flat away from direct heat. Do not machine wash or tumble dry; heat warps the strap edges and dulls the hardware plating over time.

• Faux leather strap material — smooth matte finish, no cracking at standard bend angles
• Zinc-alloy silver-tone O-rings and buckles — avoid prolonged contact with perfume or sweat
• Hand wash cold, air dry flat — machine washing damages both strap edges and hardware plating