Full Body Harness with Thigh & Calf Straps

This red faux leather full body harness extends the traditional torso cage all the way down to the calves, adding two distinct leg bands that most upper-body harnesses omit. The strap system runs from a chest yoke through three horizontal waist bands, then splits into bilateral thigh panels and two independent calf rings — a configuration that frames the entire lower body, not just the torso.

Chest and Torso Strap Layout

At the top, a V-shaped shoulder yoke converges at a central ring before splitting into two chest bands that wrap the ribcage. Three stacked horizontal bands cross the abdomen and hips, held together with silver-tone metal O-rings at the sides. Each band fastens independently, so you can leave the lowest hip band looser while keeping the chest section snug — useful when layering over a bodysuit or high-waisted bottoms.

• V-yoke shoulder construction distributes weight across both shoulders evenly
• Three adjustable waist-to-hip bands, each with individual buckle closure
• Silver-tone O-ring hardware at lateral connection points
• Approximate chest band width: 1.5 cm per strap
• Compatible with sizes fitting bust 70-100 cm and waist 60-90 cm

Thigh and Calf Strap Design

Below the hip bands, two vertical connector straps drop to a rectangular thigh frame on each leg, then continue to a calf ring sitting roughly 15-20 cm above the ankle. The calf rings are fixed-circumference loops, so they suit calves up to approximately 38 cm; wider calves may find them snug. The thigh panels use the same buckle system as the torso, giving a 10-15 cm range of adjustment per leg.

• Bilateral thigh frames with 10-15 cm adjustable range per leg
• Fixed-circumference calf rings, recommended for calves up to 38 cm
• Vertical connector straps keep thigh and calf sections aligned during movement
• One honest trade-off: the calf rings are not adjustable — measure your calf before ordering

Styling and Occasion

The red colorway pairs well with black latex shorts or a black bodysuit for a festival or editorial look — the contrast between red straps and dark base layers keeps each strap visible as a design element. Worn over an all-red lingerie set, the harness layers tone-on-tone for a more understated, fashion-forward result. The piece also works as an over-garment over a fitted turtleneck for alternative fashion events. Because the leg sections extend to the calf, short skirts and thigh-high boots both work as pairings without hiding the strap detail.

Sizing and Fit

The torso section is designed for bust measurements of 70-100 cm and waist measurements of 60-90 cm. Hip bands adjust to approximately 80-110 cm. The thigh straps accommodate thigh circumferences of 45-65 cm. As noted, the calf rings are fixed and suit calves up to 38 cm; this is the primary sizing constraint. Height is not a limiting factor for the torso section, but shorter builds (under 160 cm) may find the vertical connector straps create slack between thigh and calf bands.

Material and Care

The straps are cut from faux leather (PU-coated fabric), giving the glossy red surface visible in the product image. The material does not stretch, so the buckle adjustment range is your only give. Wipe clean with a damp cloth and mild soap — do not submerge or machine wash. Air dry flat, away from direct sunlight, which can fade the red pigment over time. Store flat or loosely coiled; tight folding along strap edges can crease the PU coating permanently.