Geometric Reflective Laser Cut Choker

The Geometric Reflective Laser Cut Choker is built from a rigid iridescent laser-cut panel shaped into a symmetrical star-and-diamond motif that sits flat against the collarbone. The panel measures approximately 14 cm wide and 8 cm tall, suspended from a slim black cord that closes at the nape. Unlike printed metallic accessories, the reflective film shifts continuously from teal to violet to gold as viewing angle changes.

Festival and Night-Out Styling

Worn against a black latex or mesh top — as shown — the iridescent panel glows under dim club lighting and becomes a focal point in flash photography. For daytime festival looks, pair it over a plain white crop top to let the color shift read clearly in natural light. The choker also works layered under a sheer button-down left open at the chest for an editorial layering effect.

• Club and rave wear: pairs with bodycon silhouettes and monochrome bases
• Festival styling: sits cleanly over tank tops without adding bulk at the shoulder
• Photography and editorial: reflective surface reacts to strobe and ring-light setups
• Costume and cosplay: geometric star motif fits futuristic or sci-fi themes

Sizing and Fit Notes

The black cord is adjustable and fits neck circumferences from approximately 32 cm to 40 cm. The choker sits at the base of the throat — not mid-neck — so it works best on necks longer than 10 cm from chin to collarbone. The rigid panel does not flex, which means it may sit unevenly on very wide or very narrow collar bones; buyers with a collarbone width under 12 cm should note the panel will extend slightly beyond the bone on both sides.

• Adjustable cord fits neck circumference 32 cm to 40 cm
• Panel width approximately 14 cm — check your collarbone span before ordering
• Sits at base of throat, not mid-neck
• Not suitable for neck circumferences above 42 cm

Material and Care

The decorative panel is cut from rigid acrylic sheet coated with a dichroic reflective film that produces the iridescent color shift. The backing cord is waxed cotton with a slip-knot or tie closure. Because the acrylic panel can crack under bending stress, avoid storing the choker folded or under weight. Wipe the panel only with a dry or slightly damp soft cloth — solvents and alcohol will lift the reflective coating. The waxed cord can be spot-cleaned with mild soap and air-dried flat.

• Panel: rigid acrylic with dichroic reflective film coating
• Cord: waxed cotton, black
• Clean panel with dry soft cloth only — no solvents
• Store flat to prevent acrylic cracking
• Reflective coating is permanent under normal wear but will degrade if scratched with hard objects