Reflective Full Body Harness Straps

This full body harness set consists of two coordinating pieces — a chest cage section with crossed reflective straps and a waist-to-thigh cage section with geometric diamond patterns — both constructed from flat white reflective tape that activates under UV and low-light conditions. The straps sit flat against the skin rather than digging in, and the small black metal rivets at every strap junction add structural reinforcement while keeping the geometric lines sharp.

Reflective Strap Construction

The harness material is a flat elastic reflective tape approximately 1.5 cm wide, the same type used in high-visibility sportswear. Under standard daylight it reads as matte white; under UV or flash photography it reflects bright silver-white. The black metal rivets — spaced at every intersection — secure the crossed strap pattern without stitching, which keeps the flat profile when worn against the body.

• Reflective tape width: approximately 1.5 cm
• Black metal rivet hardware at every strap crossing
• Chest section: crossed diagonal straps forming a cage bra silhouette
• Waist section: geometric diamond-grid cage covering hip to mid-thigh
• Thigh bands integrated at the lower hem of the waist piece

Sizing and Fit

The harness uses adjustable sliding hardware so the chest section fits torsos from approximately 70 cm to 95 cm bust circumference. The waist cage section fits hip measurements of roughly 80 cm to 100 cm. Buyers with measurements near the upper limit should note that the strap pattern becomes less geometric and the rivets may press noticeably at the widest points — this is a trade-off of the rigid rivet construction. The thigh bands stretch to fit thighs up to approximately 55 cm circumference.

• Chest section fits bust 70-95 cm
• Waist-hip cage fits hips 80-100 cm
• Thigh bands stretch to approximately 55 cm thigh circumference
• Adjustable sliders allow fine-tuning across the fit range
• Not recommended for measurements beyond the upper limits — strap geometry distorts

Festival and Rave Styling

Worn over a black bodysuit, the white reflective straps create a sharp graphic contrast for festival daywear; remove the bodysuit layer for UV rave nights when the straps glow. The two-piece construction means you can wear the chest cage alone over high-waisted pants as a standalone top, or combine both pieces over dark biker shorts for a full-coverage festival outfit. The geometric diamond grid on the hip section photographs well under both flash and UV — a practical advantage for event and costume photography.

Material and Care

The straps are reflective polyester elastic tape with a woven reflective thread integrated into the weave. The black hardware is zinc-alloy metal with a matte finish. Hand wash in cold water separately; do not machine wash as agitation can delaminate the reflective threads from the tape base. Air dry flat — avoid direct heat sources which can warp the elastic and reduce reflectivity. The reflective performance remains consistent through careful hand washing but will gradually diminish with repeated machine washing.

• Material: reflective polyester elastic tape
• Hardware: zinc-alloy black metal rivets
• Hand wash cold only — machine washing degrades reflective threads
• Air dry flat, away from direct heat
• Reflectivity reduces if machine washed repeatedly