Rainbow Reflektörlü Geometrik Kare Küpe, Şık Lazer Kesim Küpe

These square drop earrings are cut from a rainbow iridescent laser-cut acrylic panel, tilted 45 degrees so each corner points up, down, and sideways like a diamond silhouette. The laser cutting removes three stepped rectangular channels inward from each edge, leaving a bold open-square frame at the center. Under dim or colored light the surface shifts through green, yellow, pink, and violet — all from a single piece of material.

Laser Cut Detail and Color Shift

The precision laser cut produces clean, burr-free edges approximately 1 mm thick throughout. Because the acrylic carries a holographic coating rather than paint, the rainbow effect is structural — it does not chip or wash off. Indoors under warm lighting the surface reads as a warm gold-pink gradient; under UV or cool LED lighting the greens and purples dominate, making these a strong choice for festival or club environments.

• Holographic iridescent coating shifts through green, yellow, pink, and violet tones
• Concentric stepped cutouts create depth without added weight
• Clean laser-cut acrylic edges approximately 1 mm thick, no rough burrs
• Color effect is structural, not painted — will not fade or chip with normal wear

Occasion and Outfit Pairing

The square measures roughly 6 cm across the diagonal, large enough to be visible from across a room but not so heavy that extended wear becomes uncomfortable. Pair them with a simple black strappy top — as shown — and the earrings become the only accessory needed. For a festival outfit, combine with a silver or chrome chain necklace to echo the metallic hook hardware. Because the shape is geometric rather than organic, they also work alongside structured blazers and high-neck tops for an editorial daytime look.

• Night out: black strappy top, minimal other jewelry, bold lip
• Festival: silver chain necklace, holographic or metallic fabric pieces
• Editorial daytime: structured blazer, high-neck top, single-ear styling

Sizing and Fit Notes

Each earring panel is approximately 5.5 cm wide and 5.5 cm tall (the diagonal from lobe to lowest point is roughly 6 cm). The small hook fitting sits at the top corner and passes through a standard 0.8 mm pierced ear hole. The acrylic panel weighs an estimated 3-4 grams per piece — lighter than comparable metal earrings of the same size, but still noticeable after 3-4 hours of continuous wear for those sensitive to earring weight. Not suitable for non-pierced ears as no clip converter is included.

Material and Care

The earring body is laser-cut acrylic (PMMA) with a factory-applied holographic film laminate on the front face. The hook is a small metal shepherd hook in a dark finish. Wipe clean with a dry or slightly damp cloth — avoid submerging in water, as prolonged moisture exposure can lift the laminate at the edges. Store flat or in a soft pouch to prevent scratching the iridescent surface against harder jewelry. Do not use alcohol wipes or acetone near the surface.