Siyah Kadın Kemer Bağcıklı Kalın Korse Bel Aksesuarı

This black faux leather corset harness combines a wide waist-cinching band with two narrow shoulder straps that clip onto the corset top via silver square buckles. The front lace-up runs through six metal eyelets per side, letting you dial in waist compression from relaxed to firm without removing the piece.

Lace-Up Fit and Waist Cinching

The corset band sits roughly 12 cm tall at the center front, covering the natural waist and upper hip. Lacing starts at the top eyelet row and ties off at a small D-ring at the hem, so you can tighten from the bottom up for a precise fit. Because the band is rigid faux leather rather than stretch fabric, it holds its shape throughout the day rather than loosening over time.

• Six metal eyelets per side allow gradual tightening across the waistband
• D-ring hem anchor keeps the lace from riding upward during movement
• Flat-panel construction provides firm support without boning channels

Shoulder Strap Styling and Occasions

The two 1.5 cm wide shoulder straps run straight over the shoulders and fasten to the corset top with silver square buckles, adding a harness silhouette above the waist. Wear it over a white fitted tank and black trousers for a polished evening look, or layer it over a loose shirt and tuck the shirt in for a structured daytime outfit. The minimalist strap line works equally well under a blazer, where only the corset portion remains visible at the waist.

• Works over fitted tanks, bodysuits, or thin knit tops
• Pairs with high-waist trousers or midi skirts for everyday wear
• Shoulder straps visible under an open blazer for layered office-to-evening looks
• Flat black finish does not compete with patterned tops underneath

Sizing and Fit Notes

The lace-up closure accommodates a waist range of approximately 60-80 cm; buyers outside this range may find the corset either cannot close fully or sits too loose to cinch effectively. The shoulder straps are adjustable via the square buckles but are set at a fixed spacing of roughly 12 cm apart at the chest, which suits most standard shoulder widths. Very broad shoulders may find the straps slip inward. The corset band length (front to back) is approximately 28 cm, so it covers from just below the bust to the upper hip on most average-height frames.

Material and Care

The band and straps are made from matte black faux leather (PU-coated polyester), which gives a smooth, structured surface that resists minor scuffs. The back panel uses the same material without lining. Metal hardware is silver-tone zinc alloy. Because the outer surface is PU, do not machine wash — wipe clean with a slightly damp cloth and air dry flat. Avoid prolonged exposure to direct sunlight, which can cause the PU coating to crack over time.

• Outer: matte PU faux leather over polyester base
• Hardware: silver-tone zinc alloy buckles and eyelets
• Care: wipe clean only — no machine wash, no tumble dry
• Store flat or rolled to prevent permanent crease lines in the panel