Siyah Kadın Kemer Deri Vücut Aksesuarı Halka Detaylı

This black faux leather chest harness is built around a structured X-back shoulder construction that crosses at a central junction, dropping into a vertical center strap fitted with a rectangular silver buckle. Two horizontal chest bands frame the torso front, each anchored by a polished silver O-ring at the center — a detail that sets it apart from single-ring cage styles.

Chest Strap Styling Options

Wear it directly over a plain white or black fitted top for an everyday layering effect, or layer it over a sheer mesh bodysuit for festival or night-out looks. The X-back design stays visible under an open blazer or oversized jacket, adding structure without bulk. For a more minimal approach, pair it over a bandeau bra and high-waist trousers — the dual O-rings sit at mid-chest and become a focal point without covering the waist.

• Over a sheer mesh top: editorial or concert styling
• Layered on a fitted turtleneck: structured cold-weather outfit
• Worn alone over a bandeau: festival or beach cover-up layering

Sizing and Fit Details

The horizontal chest bands adjust independently via side buckles, accommodating chest measurements from approximately 75 cm to 100 cm. The shoulder straps extend and shorten at the X-junction, so torso length is also adjustable within roughly 35 cm to 50 cm shoulder-to-underbust range. This harness sits best on a mid-range torso; very short torsos may find the X-back junction sits too high, and very long torsos may find the bottom band floats above the natural underbust.

• Chest band range: approx. 75 cm to 100 cm circumference
• Torso range: approx. 35 cm to 50 cm shoulder-to-underbust
• Strap width: approx. 1.5 cm flat smooth strips
• Not suited for torsos shorter than 35 cm shoulder-to-underbust

Material and Care

The straps are cut from smooth faux leather (PU-coated fabric) — lightweight and flexible compared to genuine leather, which means it conforms quickly to body shape but will show creasing at buckle points over time with heavy use. Hardware is silver-tone zinc alloy. Wipe clean with a damp cloth only — do not submerge in water or machine wash, as water weakens the PU bond at stitch points. Store flat or loosely coiled to prevent strap kinking.

• Body: PU faux leather over woven base fabric
• Hardware: silver-tone zinc alloy O-rings and rectangular buckles
• Care: wipe clean, air dry, store flat
• Trade-off: PU surface may crease at high-flex buckle zones over time

Buckle Closure System

Each strap terminates in a standard pin-and-hole buckle — no tools needed to adjust, and all buckles use the same hardware style for a consistent look. The center vertical buckle controls overall chest band tension, while shoulder buckles fine-tune the X-back angle. Total adjustable points: five separate buckles across the full harness.