Strappy Garter Body Harness with Adjustable Straps

This burgundy velvet body harness combines a chest cage with four garter-style leg bands — all adjustable — into one continuous piece. Narrow 1 cm velvet straps form a geometric diamond pattern across the torso, while gold-tone slide buckles let you fine-tune every section for a secure, custom fit.

Chest Cage and Garter Design

The harness opens at the neckline with a thin collar strap that travels down the sternum, branching into a diagonal crisscross grid across the ribs. Below the waist, four independent garter straps drop from a hip band and each end with a small gold-tone loop at the thigh. This split structure means the chest and leg sections move somewhat independently, which works well over high-waisted bottoms but requires careful size selection for petite torsos shorter than 64 cm waist-to-shoulder.

• Chest cage span: approximately 28-36 cm across, adjustable via side slides
• Four garter straps, each with one slide buckle for length adjustment
• Gold-tone metal hardware — rings and slide buckles throughout
• Continuous single-layer velvet construction, no lining or padding
• Not compatible with standard stocking clips — loops are decorative, not functional garter clips

Burgundy Velvet Fabric Details

The straps are cut from a smooth, matte-finish velvet ribbon with a soft texture that sits flat against skin without rolling. Velvet composition is approximately 80% polyester, 20% nylon, giving the straps enough stretch to accommodate the adjustment range without losing shape over time. Because velvet can mark under pressure, avoid wearing under very tight outerwear for extended periods — light surface pressure flattening may occur but typically recovers after airing.

Layering and Occasion Styling

The burgundy color pairs directly with neutral outerwear and makes the harness readable as a visible accessory rather than pure undergarment. Two outfit combinations that work well:

• Wear over a white button-down shirt left open — the chest cage shows through and the garters frame high-waist trousers
• Styled as shown: draped under an oversized teal or cobalt blazer worn open, with the leg straps visible below the hem
• Layered over a bodysuit for festival or concert dressing where the straps add dimension without full exposure
• Over a silk slip dress for editorial or styled photo shoot use

Sizing and Fit Range

The harness fits a torso circumference of roughly 70-95 cm chest and a hip circumference of 80-105 cm, based on the adjustment range of the slide buckles. The garter leg straps comfortably reach thighs up to approximately 58 cm in circumference. Taller frames above 175 cm may find the torso section sits higher than intended; shorter frames below 160 cm may need to take in the hip band fully. One size only — if your measurements fall near the upper limit of either range, size up in outerwear to wear over.

Material Care Instructions

The velvet straps require hand wash in cold water only, using a mild detergent. Do not machine wash, tumble dry, or iron — heat damages velvet pile and can warp the slide buckles. Lay flat to dry away from direct sunlight, which fades the deep burgundy tone. The gold-tone hardware is zinc alloy; pat dry immediately after washing to prevent surface tarnish. Store flat or loosely coiled — do not fold tightly at the buckle points.