Taba Kadın Kemer Suni Deri Halka Detaylı Kalın

This underbust waist cinch is built from smooth tan faux leather panels that hold their shape without boning, sitting flush against the torso from just below the bust to the top of the hips. The curved side cutouts are cut into the body of the piece itself — not added straps — giving the silhouette a clean, architectural edge rather than a busy layered look.

Panel Construction and Hardware

Unlike thin strap-only harnesses, this cinch uses wide flat panels — roughly 12 cm at the tallest point — that distribute pressure evenly across the midsection. The upper edge follows a gentle wave, framing the underbust without digging. Hardware is brass-tone throughout: two D-rings sit on the upper panel for accessory attachment, and four stud rivets anchor the side adjustment tabs. The side buckles let you fine-tune fit by approximately 4 cm in either direction.

• Wide structured panel approximately 12 cm at center front
• Brass-tone D-rings on upper edge for belt or chain attachment
• Four rivet studs securing side adjustment tabs
• Side buckle closure with roughly 4 cm range of adjustment
• Smooth cognac tan faux leather — no textured grain or embossing

Styling and Occasion

The tan colorway reads as a neutral in the same way a camel coat does — it pairs with white, cream, black, and olive without competing. Worn over a fitted ribbed turtleneck and straight-leg trousers, the cinch breaks the monochrome and adds a fashion-forward layer for everyday use. For evening, position it over a satin slip dress and the gold hardware picks up warm light cleanly. The underbust cut means the piece works even with higher-waisted bottoms since it does not extend over the hip.

• Over a ribbed turtleneck with straight trousers for an affordable everyday fashion statement
• Layered on a satin slip dress for evening wear
• Styled with a blazer and wide-leg pants for a seasonal office-appropriate look

Sizing and Fit

The cinch is designed to wrap the natural waist and lower ribcage. It fits comfortably on a waist measuring 63 cm to 82 cm (approximately 25 in to 32 in). The panel height of roughly 12 cm means shorter torsos may find the piece sits at the underbust and hip simultaneously, which reduces layering flexibility — a genuine trade-off worth considering before ordering. The piece does not include boning or internal structure beyond the faux leather itself, so it relies on the wearer's own torso for shape.

Material and Care

The outer shell is smooth PU faux leather with no visible lining on the inner surface — the same material contacts the skin. Wipe clean with a dry or lightly damp cloth; do not submerge in water or machine wash, as moisture can cause delamination at the panel edges over time. Store flat or rolled loosely to prevent permanent creasing along the cutout curves. The brass-tone hardware is zinc alloy and should be kept dry to avoid surface patina.

• Outer: smooth PU faux leather, tan/cognac colorway
• Hardware: zinc alloy with brass-tone finish
• Care: wipe clean with dry cloth only — no machine wash
• Storage: lay flat or roll loosely to protect curved cutout edges