Tarz ve Şık Choher, Halka Detaylı Tarz Deri Kolye

The Black Faux Leather O-Ring Choker with V-Strap is a wide-band neck accessory built around a V-cut faux leather panel that angles down to a silver-toned O-ring at the center front. Two silver rivets anchor the strap junction, adding a hardware detail that reads as intentional rather than decorative. The band sits approximately 4 cm wide against the throat — wider than a standard choker strip, which means it holds its shape without curling.

Neck Fit and Sizing

The choker is designed for neck circumferences of roughly 32 cm to 38 cm, with a buckle or snap closure at the back that allows fine adjustment within that range. It sits best on medium to long necks where the V-strap has room to angle downward visually. Very short necks may find the 4 cm width covers too much of the collarbone area. The band lies flat and does not gap, so it photographs cleanly against bare skin.

• Fits neck circumference approximately 32–38 cm
• Band width approximately 4 cm — wider than a standard 2 cm choker strip
• Adjustable back closure for a personalized fit
• Not recommended for neck circumferences above 40 cm

Daily and Evening Outfit Pairings

The black V-strap reads clearly against pale or warm-toned skin, which is why it pairs strongly with low-cut necklines — V-neck blouses, square-neck tops, or strapless dresses where the choker fills the neck space without competing with another accessory. For a daytime look, layer it over a plain white turtleneck so only the O-ring peeks below the collar. For evening, wear it alone against bare skin with a satin slip dress or structured blazer. The silver O-ring can hold a small charm or pendant if you want to add a personal layer to the look.

• Pairs with V-neck and square-neck tops for a matched neckline angle
• Works over a turtleneck for an understated layered effect
• Complements satin slip dresses for evening occasions
• Silver O-ring can hold a small pendant charm

Material and Care

The outer surface is faux leather (PU material) — matte black, smooth-grain texture with moderate flexibility so it conforms to neck movement without cracking under normal wear. The inner surface has a thin lining layer to reduce direct contact friction against the skin. Do not submerge in water; wipe the outer surface clean with a dry or very lightly damp cloth. Avoid prolonged sun exposure, which can fade the matte black finish over time. The silver-toned hardware is zinc alloy — buff with a dry cloth if it dulls.

Hardware Details

Two silver rivets sit at the point where the V-strap meets the main band, providing a structural anchor that also gives the piece an industrial-accessory feel distinct from plain leather strips. The O-ring diameter is approximately 2.5 cm, large enough to be visible at mid-chest level but not so heavy that it pulls the band downward. All metal parts are silver-toned zinc alloy — they will not rust with normal indoor wear, but prolonged moisture contact should be avoided to preserve the finish.