Adjustable Faux Leather Overlay Chest Harness

This black faux leather chest harness is built around wide overlay strap panels that frame the torso in two parallel columns, held together by a structured waist belt and connected at the shoulders with silver D-rings. The result is a defined silhouette that works as a standalone piece or layered over a mesh top or fitted tee.

Strap Construction and Hardware

The harness uses multiple horizontal cross-straps riveted to two vertical side columns, giving the overlay effect visible in the image. Each junction point is reinforced with a silver metal rivet, and the shoulder connections use open D-rings approximately 2.5 cm in diameter. The center waist belt features a rectangular silver buckle closure roughly 4 cm wide, allowing single-point adjustment for the entire lower section.

• Two vertical side columns connected by 4 horizontal cross-straps
• Silver D-rings at shoulder points, approximately 2.5 cm diameter
• Rectangular silver buckle at waist, approximately 4 cm wide
• Flat rivets at every strap junction for structural reinforcement
• Strap width approximately 1.5-2 cm throughout

Sizing and Fit

The multiple adjustable buckle points mean this harness can fit a chest circumference from approximately 75 cm to 100 cm. The waist belt adjusts independently across a range of roughly 65 cm to 90 cm. It sits best on a proportional torso where the distance from shoulder to natural waist is between 35 cm and 45 cm — very short or very long torsos may find the vertical strap spacing less flattering. Note: the open-frame overlay design leaves the chest area uncovered, so it is intended to be worn over a base layer or as a costume accent piece rather than as standalone coverage.

• Chest circumference range: approximately 75 cm to 100 cm
• Waist belt range: approximately 65 cm to 90 cm
• Shoulder-to-waist fit range: 35 cm to 45 cm
• Not recommended for torsos outside these ranges — strap proportions will shift

Material and Care

The straps are made from smooth vegan faux leather bonded over a flexible backing, which keeps the piece lightweight at an estimated 180-220 g. The silver-tone hardware is zinc alloy, which resists light tarnishing but should be kept away from moisture for long-term durability. Wipe the faux leather surface with a dry or slightly damp cloth — do not submerge in water or use solvent-based cleaners, as these degrade the bonded surface coating over time.

• Material: smooth vegan faux leather bonded construction
• Hardware: zinc alloy silver-tone, tarnish-resistant in dry conditions
• Weight: approximately 180-220 g
• Care: wipe clean with damp cloth, air dry flat
• Avoid prolonged exposure to direct sunlight to prevent surface cracking

Styling and Occasion

For a festival or concert outfit, layer this harness over a sheer black or white mesh crop top — the overlay straps remain visible through the fabric while the base layer adds coverage. For a night-out look, wear it over a fitted sleeveless bodysuit and pair with high-waisted trousers; the structured waist belt reinforces the waist definition already created by the bodysuit. The piece also works as a costume accent for themed events, where its adjustable daily-wear buckle system means quick on and off without tools.