Caged Chest Harness with O-Ring Details

The Caged Chest Harness with O-Ring Details is built from narrow-cut red faux leather straps approximately 1.2 cm wide, assembled into a geometric cage silhouette that frames the chest. Three polished silver O-rings anchor the vertical and horizontal strap intersections, giving the piece its structural definition. The bottom section ends in two long crossed bands that wrap and tie at the back, making size adjustment straightforward without additional hardware.

Strap Layout and Cage Structure

The harness uses a five-strap cage formation: two diagonal shoulder straps converge at a top-center O-ring, two vertical chest straps frame each side of the torso, and a horizontal underbust band connects them at a second O-ring. A third silver O-ring anchors the waist junction. Silver dome rivets are spaced every 4-5 cm along the straps, reinforcing the join points and adding texture visible even under sheer layering pieces.

• Three silver O-rings at neck, chest center, and underbust junction
• Dome rivets spaced approximately 4-5 cm apart along all strap lengths
• Two long crossed back ties for custom sizing without buckle tools
• Cage geometry creates a diamond window across the chest
• Strap width approximately 1.2 cm for a defined, graphic line

Styling and Occasion

Worn over a fitted black turtleneck, the red straps read as a bold color-block accessory against a neutral base — practical for an affordable everyday fashion statement at a gallery opening or a night out. For festival or concert dressing, layer it directly over a red or white mesh bodysuit so the cage pattern stays visible. A third option: wear it over a structured blazer with only the top shoulder straps peeking out, keeping the look editorial rather than costume-heavy. The piece works best when the garment underneath has a clean, solid color that does not compete with the strap geometry.

Sizing and Fit

The crossed back ties allow the underbust band to fit a chest circumference range of roughly 70-95 cm; buyers above 95 cm chest may find the cage portion sits too low or the back ties too short to secure comfortably. Shoulder strap length is fixed, so the harness suits torso lengths typical for EU sizes 34-42. The straps do not stretch, so if you are between sizes, size up and trim the back tie excess rather than pulling the cage section out of shape. This is a flat-lay piece — it will not provide lift or support, which is an honest trade-off for the visual effect.

Material and Care

Straps are cut from smooth-finish red faux leather (PU coated fabric) with no visible lining on the narrow strips. The hardware is silver-tone zinc alloy — it will not rust from brief moisture exposure but should be dried promptly. To clean, wipe straps with a damp cloth and mild soap; do not submerge or machine wash, as prolonged water contact causes PU delamination. Store flat or loosely rolled to prevent permanent crease lines in the straps. Avoid direct sunlight storage, which fades the red pigment faster than indoor storage.