Choker Body Harness with X-Strap Chest and O-Ring Waist Belt

This black faux leather body harness connects a fitted choker collar to a crossed chest panel and a wide waist band through a single vertical center strap, creating a structured silhouette without bulk. The waist band measures approximately 4 cm wide and sits at the natural waist, while narrow 1.5 cm shoulder and chest straps form a distinct X-cross pattern across the torso. All hardware is silver-tone metal — rivets, buckles, and a centered silver O-ring — with no gold or mixed-metal accents.

Styling with Layered Outfits

Worn over a plain black fitted turtleneck, the harness reads as a structured layering piece rather than underwear. Pair it over a sheer blouse for an editorial look, or wear the waist band alone over a blazer by unclipping the chest straps. The choker sits close to the throat — approximately 1.5 cm wide at the neck — so avoid high-necked base layers that compete with it. Works well with high-waisted trousers or a pencil skirt to anchor the waist band at the right visual point.

• Over a sheer black blouse for evening occasions
• Layered on a fitted white shirt for a contrast styling detail
• Combined with a structured blazer using only the waist section

Adjustable Sizing and Strap Fit

The chest and shoulder straps each have a metal pin-buckle allowing approximately 8 cm of adjustment range per strap. The waist band closes at the back with a standard single-prong buckle and fits waist circumferences roughly between 62 cm and 80 cm. The choker has 3 snap positions spanning about 32 cm to 38 cm neck circumference. This harness is not suitable for very full busts above a D cup, as the X-cross straps sit flat against the sternum and may not distribute evenly across a larger chest. Standard XS–L sizing applies for the waist; size up if your waist is above 76 cm.

• Waist band adjustable from approximately 62 cm to 80 cm
• Choker spans 32 cm to 38 cm neck circumference
• Per-strap buckle allows 8 cm adjustment each
• Best suited for bust up to D cup for flat strap alignment

Faux Leather Material and Care

The straps and waist band are made from smooth black vegan leather — a polyurethane-coated fabric backing — which gives a clean, uniform surface without the grain variation of animal leather. The material is wipe-clean only: use a lightly damp cloth, then pat dry. Do not submerge in water or machine wash, as prolonged moisture causes the PU coating to separate from the backing. Hardware is silver-tone zinc alloy; keep it dry to prevent tarnishing. The one honest trade-off: PU faux leather is less breathable than fabric alternatives and can feel warm against skin in high-heat conditions.

• Smooth black polyurethane vegan leather straps
• Silver-tone zinc alloy hardware throughout
• Wipe-clean only — no machine washing
• PU coating may feel warm against bare skin in summer

Hardware and Construction Detail

Eight visible silver rivets reinforce the strap junction points where the X-cross meets the center vertical and where straps attach to the waist band. The O-ring at the waist center measures approximately 3 cm inner diameter and is a fixed decorative ring, not a removable attachment point. The center vertical strap runs from the choker base to the waist band top — roughly 30 cm in length on a medium torso — keeping all sections aligned without additional hardware. This single-piece construction means the choker and waist band cannot be worn independently.