Faux Leather Full Body Harness with O-Ring Chain

This black faux leather full body harness combines a choker collar with an O-ring center detail, a structured chest band, and a multi-strap cage waist section that frames the torso in four horizontal bands. The silver-tone hardware — rivet studs, D-rings, and spring-clasp chains — runs throughout, giving the piece a consistent industrial-fashion finish rather than a plain accessory look.

Chest and Collar Construction

The harness opens at the top with a 0.9 cm wide collar band fastened at the nape, feeding into an O-ring at the throat. Two shoulder straps carry the load down to a horizontal chest strap that sits above the bust line. A secondary O-ring at the sternum anchors a short chain link connector, which is the piece's most visible detail from the front.

• Collar band width: approximately 0.9 cm, with a rivet-stud row along its length
• Central O-ring diameter: approximately 3.5 cm, silver-tone zinc alloy
• Spring-clasp chain connector between sternum ring and waist ring: roughly 6 cm drop
• Shoulder straps adjustable via sliding buckles on each side
• Chest band sits 4-5 cm above the bust, does not replace a bra — wear over fitted lingerie top

Cage Waist Band Fit

Below the chest section, four parallel horizontal bands span the midriff and wrap the waist, connected by two vertical side straps to form an open cage. This is the design's defining structure: the cage covers roughly 12-14 cm of vertical torso space, sitting between the lower rib and the hip. A lower O-ring sits at the navel level and can attach optional leg strap accessories (not included). The waist cage fits comfortably on waist circumferences from 60 cm to 80 cm; the sliding buckles allow up to 8 cm of adjustment per strap. Waist measurements above 82 cm may find the cage bands sit too close together.

• Four horizontal cage bands, each 0.9 cm wide
• Adjustable waist range: 60-80 cm via individual buckle slides
• Lower navel O-ring: 3 cm diameter, same silver-tone finish as chest ring
• Side vertical straps keep cage spacing even across different torso lengths
• Honest trade-off: cage bands may shift slightly during movement — a fitted base layer helps keep them positioned

Styling and Occasion

The harness works as an outer-layer fashion piece over a plain black long-sleeve crop top and high-waist trousers for an everyday alternative streetwear look. For evening events, layer it over a structured bralette with wide-leg pants — the silver hardware reads as jewelry at that scale. It also pairs with a bodysuit as an accessory layer for festival or themed-party outfits. Because the collar and chest section are independent from the waist cage, you can tuck the upper section under a blazer lapel and let the waist cage show through an open-front jacket for a subtler look.

Material and Care

The straps are cut from vegan faux leather (PU-coated fabric backing), which gives a smooth matte surface similar to genuine leather without animal products. Hardware is zinc alloy with a silver electroplate finish — resistant to everyday wear but should be kept away from water to preserve the plating. The PU surface can be wiped with a dry or very slightly damp cloth; do not submerge in water, do not machine wash, and keep away from direct heat sources like radiators or prolonged sunlight, which can cause PU to peel at stress points over time.

• Strap material: PU faux leather over woven fabric backing
• Hardware: zinc alloy, silver electroplate — do not soak
• Care: wipe clean with dry cloth; no machine wash, no tumble dry
• Storage: hang flat or coil loosely — avoid tight folding at buckle points