Harness Deri Jartiyer Büstiyer Takım

This black faux leather full body harness set combines a structured chest frame, waist band, and a two-strap thigh garter into one coordinated lingerie set. The cross-panel chest detail is the standout feature — two flat cross-shaped patches sit across the chest, anchored by silver-tone O-rings at the center and shoulder junctions.

Chest and Waist Strap Construction

The upper body section uses approximately 1.5 cm wide faux leather straps that run from the shoulders across the chest and converge at a central O-ring below the bust. A separate horizontal band sits at the natural waist, connected by a vertical front strap. This layered structure creates visible geometric lines over skin or worn over a fitted top for a daily-use layering look.

• Shoulder-to-shoulder span adjustable via buckle sliders
• Chest cross patches measure approximately 8 cm x 8 cm each
• Waist band closes at back with a single metal slider buckle
• Silver-tone O-ring hardware throughout for uniform finish

Garter Leg Straps and Fit

The thigh garter portion consists of three parallel straps encircling the upper thigh, connected by a front vertical anchor strap that attaches to the waist band. The garters are sized for thighs between 45 cm and 60 cm in circumference and may feel snug on thighs above 62 cm. This set is best suited for EU sizes 34-42; the straps offer limited adjustment beyond that range, which is an honest limitation to consider before ordering.

• Three-strap thigh garter per leg, adjustable at each band
• Vertical connector strap anchors garters to waist section
• Designed for thigh circumference 45-60 cm
• Not recommended for thighs above 62 cm as pressure may be uncomfortable

Occasion and Outfit Styling

Worn directly over bare skin as intimate lingerie, the set reads as a complete look on its own. For a bolder festival or editorial outfit, layer the chest harness over a black sheer long-sleeve top with high-waisted wide-leg trousers, leaving the garters visible below a mini skirt or shorts. A third option: pair the waist-and-garter portion under a blazer dress with the straps peeking above the hem — this gives a structured silhouette suited to low-lit event settings.

Material and Care Instructions

The straps are constructed from faux leather (PU-coated polyester) with no additional lining on the strap surfaces. Hardware is silver-tone zinc alloy. To clean, wipe surfaces with a damp cloth and mild soap only — do not submerge in water or machine wash, as prolonged moisture degrades the PU coating. Store flat or loosely rolled to prevent permanent crease marks in the faux leather.

• Material: PU faux leather over polyester base
• Hardware: silver-tone zinc alloy O-rings and slider buckles
• Care: wipe clean only, no machine wash, no soaking
• Store flat to avoid crease damage to PU surface