Full Body Harness with Cross Bust and Detachable Garter

This black faux leather full body harness arrives as a coordinated two-piece set: a structured chest harness with built-in cross-shaped bust panels and an attached choker collar, plus a separate hip-and-thigh garter piece with double adjustable leg straps. The two sections connect or wear independently, giving you genuine styling flexibility without buying separate pieces.

Cross Bust Design and Hardware

The defining detail is the pair of solid faux leather X panels that sit across each bust cup, secured with silver-tone rivets approximately 0.8 cm in diameter. A central O-ring at the underbust anchors the lower torso straps, while a matching O-ring at the choker front adds a second focal point. All buckles and connectors use a brushed silver finish — consistent hardware color across the entire set keeps the look cohesive.

• Choker collar with front O-ring, roughly 1.5 cm strap width
• Cross bust panels in solid matte faux leather, each panel approximately 8 cm across
• Central underbust O-ring connector, standard 2.5 cm diameter
• Silver-tone adjustable buckles on shoulder and torso straps
• Detachable garter section with waist band and two independent thigh loops

Sizing and Fit

The harness uses a fully adjustable strap system with no fixed cup sizing — most wearers between bust 75 cm and 100 cm and hip 85 cm to 110 cm can dial in a comfortable fit. The garter thigh loops adjust from roughly 45 cm to 62 cm circumference, fitting slim to average thigh measurements. Very petite frames (bust under 72 cm) may find the cross panels sit wider than intended; very full thighs above 64 cm circumference will reach the buckle limit.

• Chest straps adjust across a roughly 25 cm range
• Garter waist band accommodates hips from 85 cm to 110 cm
• Thigh loops: adjustable range approximately 45-62 cm circumference
• Not recommended for thighs over 64 cm — buckles reach maximum extension
• Both pieces sold together; worn as a set or separately over clothing

Material and Care

Straps and panels are cut from smooth matte faux leather (PU material) with no fabric lining on contact surfaces — the clean underside is finished PU, which feels slightly cool against skin. Hardware is zinc-alloy with a silver-tone electroplate. Because faux leather does not breathe, extended wear in warm conditions may feel sticky; this is a standard trade-off of the material. Wipe clean with a damp cloth only — do not submerge in water, machine wash, or use solvent-based cleaners, as these degrade the PU coating and cause peeling within a few cycles.

• Material: smooth matte PU faux leather, no genuine animal hide
• Hardware: zinc-alloy with brushed silver-tone electroplate
• Care: surface wipe with damp cloth, air dry flat
• Avoid perfume, oil, and alcohol contact — accelerates PU surface degradation

Styling and Occasion

The cross bust panel reads as a structural bralette silhouette, so the chest harness works worn over a black sheer blouse or directly against skin under an open blazer for a concert or editorial night-out look. The detachable garter pairs over opaque tights or fishnet stockings, and the waist band sits neatly beneath a high-waisted skirt without bulging. For a daily fashion accessory approach, layer just the chest harness over a fitted long-sleeve tee — the cross panel and choker add visual structure without the full garter. Because both pieces detach, you get three distinct outfit configurations from one set.