Full Body Harness with Thigh Garters

This black faux leather body harness pairs a structured chest cage with dual thigh garters, creating one connected silhouette from shoulder to upper thigh. Flat 1 cm straps run in a crisscross pattern across the chest, gather at a waist band with a center pin buckle, then extend into two independent thigh bands — each anchored by silver O-rings at the crossing points.

Chest and Waist Strap Layout

The chest section features two diagonal straps that cross at the sternum and loop behind the neck, forming a halter-style frame without a bra cup. A horizontal band sits just below the bust, and a second band wraps the natural waist — both adjustable through the same center front buckle. The layered waist band adds definition without pinching, and the overall strap weight is light enough for extended wear over a bodysuit or lingerie set.

• Two crisscross chest straps meeting at a center sternum point
• Horizontal under-bust band plus separate waist wrap band
• Single center pin buckle controls waist tension
• Silver-tone O-rings at all four crossing junctions

Thigh Garter Construction

Each thigh garter is a self-contained four-strap cage — two horizontal bands connected by two vertical straps — so the garter sits above the knee without sliding. The garters attach to the waist section via short drop straps, keeping them aligned with the hips. Not adjustable at the thigh band itself, so waist-to-thigh drop length is fixed; buyers with a longer torso or higher hip-to-thigh ratio should measure before ordering.

• Four-strap cage design per thigh holds position without elastic
• Short drop straps link garters directly to waist band
• Silver stud rivets secure every strap junction on the thigh section
• Garter opening fits approximately 45-55 cm thigh circumference

Sizing and Fit

The harness is designed for waist measurements between 60 cm and 80 cm; the chest straps accommodate bust frames up to approximately 90 cm. The neck strap is not adjustable in length, which works well for torso heights between 155 cm and 175 cm. Wearers taller than 175 cm may find the thigh garters sit higher than intended, while those shorter than 155 cm may find extra slack in the waist-to-thigh drop. Sizing up is rarely needed — fit to your waist measurement first.

Material and Care

The straps are cut from smooth matte faux leather (PU-coated fabric backing), which keeps the surface scuff-resistant under light use. Hardware is zinc-alloy with a silver-tone finish; contact with moisture over time can dull the plating, so pat dry after wear. Do not machine wash — wipe the straps with a damp cloth and mild soap, then air-dry flat away from direct heat. The faux leather will crack if folded sharply at the same point repeatedly; store flat or loosely coiled.

• Matte black PU faux leather — 1 cm strap width throughout
• Zinc-alloy silver-tone buckles, O-rings, and stud rivets
• Wipe-clean only — no machine wash, no tumble dry
• Store flat or loosely coiled to prevent crease cracking