Full Body Harness with Thigh Straps and O-Ring Detail

This black faux leather full body harness connects a chest rig, a wide adjustable waist band, and double thigh straps into one coordinated piece. The gold-tone O-ring sits at the sternum where the shoulder straps converge, creating a focal point without extra hardware. The thigh section features two parallel 1.5 cm wide straps per leg, positioned above the knee for a structured silhouette.

Strap Configuration and Hardware

Each section of this harness operates independently through its own set of adjustment buckles, so chest, waist, and thigh fits are set separately rather than all pulling from a single point. The shoulder straps are approximately 1.5 cm wide and run from the upper chest over each shoulder, meeting at the sternum O-ring. A single vertical strap bridges the chest rig to the waist band, which spans roughly 4 cm in width and fastens with three snap closures across the front. All metal hardware is gold-tone — buckles, D-rings, and the central O-ring — providing a consistent warm-metallic accent against the black body straps.

• Gold-tone O-ring at sternum, approximately 3 cm diameter
• Shoulder straps adjustable from approximately 35 cm to 55 cm total length
• Wide waist band with three front snap closures
• Double thigh straps per leg, each 1.5 cm wide
• All buckles slide-adjustable; no tools required for fitting

Sizing and Fit

The harness is designed to fit chest circumferences from approximately 85 cm to 105 cm and waist circumferences from 70 cm to 95 cm. Thigh straps comfortably accommodate thigh circumferences from roughly 48 cm to 62 cm. Wearers outside these ranges may find the thigh section too tight or the waist band unable to close fully — measure before ordering. The chest piece sits best on a relatively flat chest; it is not structured to provide lift or shaping.

• Chest circumference range: 85 cm to 105 cm
• Waist circumference range: 70 cm to 95 cm
• Thigh circumference range: 48 cm to 62 cm
• Not suitable for thigh circumferences above 65 cm
• Fits most average to athletic male builds within the stated ranges

Material and Care

The straps are made from smooth faux leather (PU-coated fabric), which gives the matte black finish visible in the product images. The waist band inner surface has a thin fabric backing to reduce friction against the skin during extended wear. Because PU faux leather can crack if submerged or machine washed, clean only by wiping with a damp cloth and a small amount of mild soap, then air dry flat away from direct heat. Avoid folding the straps sharply during storage to preserve the smooth surface finish over time.

• Strap material: smooth PU faux leather over woven base
• Hardware: gold-tone zinc alloy buckles and O-ring
• Waist band inner surface: thin fabric-backed lining
• Care: wipe clean only — do not machine wash or submerge
• Storage: lay flat or hang to prevent crease marks in the PU surface

Styling and Occasion

For festival and outdoor event outfits, wear the harness over a plain black fitted t-shirt or mesh tank; the gold O-ring reads well at a distance against dark fabric. For a stage or club look, pair it directly over bare skin with black fitted trousers, letting the thigh straps show below the waistband. The structured silhouette also layers over a bomber jacket worn open, with the chest straps visible in the lapel gap. Because the waist band sits at the natural waist rather than the hip, it works best with mid-rise bottoms rather than low-rise cuts.