Full Chest Body Harness with Multi O-Ring Design

This black faux leather chest harness wraps the torso in a structured cage pattern built around three silver-tone metal O-rings — one at the collar, one at the sternum, and one at the lower chest — connected by flat straps studded with round silver rivets. The geometry is fixed by design, so the visual impact reads immediately without adjustment.

Chest Cage Styling Options

The harness works as a standalone top for festival or club wear, or layered over a mesh tank or unbuttoned shirt for a toned-down street look. Because the straps are approximately 1.8 cm wide, they sit cleanly over most fabric without bunching.

• Worn shirtless over dark trousers for a club-ready look
• Layered over a black mesh long-sleeve for cooler venues
• Paired with a semi-open blazer for an editorial street-style outfit

Sizing and Chest Fit

The harness is sized for a chest circumference of approximately 85-105 cm. The collar strap and under-chest band have snap or buckle closures at the back that allow about 10 cm of adjustment range. Wearers with a chest below 80 cm may find the lower ring sits too high on the sternum; those above 110 cm may find the strap tension uncomfortable at the shoulders. This is a chest-only harness — it does not extend below the ribs.

• Fits chest circumference approximately 85-105 cm
• Approximately 10 cm adjustment range at back closures
• Chest-only coverage — does not extend to the waist
• Not recommended for chest circumferences below 80 cm or above 110 cm

Faux Leather Material and Care

The straps are cut from vegan faux leather with a smooth matte surface and no visible grain texture. The O-rings and studs are silver-tone base metal. Faux leather does not breathe, so extended wear in warm conditions may feel warm against the skin — a light dusting of talc on the inside helps. Wipe clean with a damp cloth; do not submerge in water, machine wash, or expose to prolonged direct sunlight, which can dry out the surface.

• Vegan faux leather straps, approximately 1.8 cm wide
• Silver-tone metal O-rings and rivet studs
• Wipe-clean only — no machine washing
• Avoid prolonged heat and direct sunlight to prevent surface cracking

Hardware and Construction Details

The three O-rings range from roughly 3 cm to 5 cm in diameter, with the largest positioned at the sternum for maximum visual focus. Studs are set at regular intervals along every horizontal and vertical strap, adding a consistent textural rhythm without adding meaningful weight. The back closure uses a standard post-and-hole buckle system that most wearers can fasten solo without a mirror. The harness sits flat after a few wears as the faux leather relaxes slightly at bend points.