İnce Şeritli Göğüs Ve Bacak Detaylı Ayarlanabilir Kadın Deri Fantezi Harness

This four-piece black faux leather harness set covers the full silhouette in one coordinated look: a neck-to-waist chest cage, dual garter straps, double-band thigh wraps, and a pair of wrist cuffs — all fastened with gold-tone O-ring hardware. Unlike single-piece chest harnesses, this set layers from collar down to calf, so every angle is styled without mixing separates.

Chest & Collar Construction

The chest section starts with a fitted neck collar approximately 2 cm wide, dropping into two vertical front straps that frame the sternum. A horizontal cross-strap at mid-chest creates the cage silhouette, while a single center strap continues to the waistband. All adjustment points use gold-tone O-rings and slide buckles so the fit can be set without tools. The chest assembly sits flat against the body even during movement, which makes it practical over a bodysuit, bralette, or sheer top.

Garter Straps & Thigh Bands

Two garter straps descend from the waistband to connect with the thigh sections, following the outer leg line. Each thigh wrap consists of two parallel 1.5 cm straps held together by a small O-ring connector at the outer side. A third narrower strap continues past the knee toward the lower leg, giving the set its full-length coverage. The total adjustable range on the leg sections accommodates thigh circumferences from roughly 48 cm to 62 cm; buyers with thigh measurements outside this window may find fit difficult to maintain.

• Chest cage frames sternum with two vertical front straps and one horizontal cross-strap
• Neck collar approximately 2 cm wide, closes at back with slide buckle
• Garter straps adjustable along the full length from waist to mid-calf
• Double thigh bands fit circumferences of approximately 48-62 cm
• Gold-tone O-ring hardware at every junction point

Wrist Cuffs & Set Details

The included wrist cuffs are approximately 5 cm wide, made from the same smooth faux leather as the harness straps, and close with a stud-press closure rather than a buckle — they sit flat without bulk under sleeve hems. Each cuff features a single gold-tone O-ring detail centered on the outer face. The full set of four pieces ships together, so the collar, chest, leg, and cuff components share identical strap width and hardware finish for a unified appearance.

• Wrist cuffs approximately 5 cm wide with press-stud closure
• Gold-tone O-ring centered on each cuff outer face
• Four-piece set: collar-chest, garter-thigh, lower-leg straps, 2x wrist cuffs
• Strap width consistent at approximately 1.5 cm throughout the body sections
• Faux leather surface is smooth with a slight sheen — shows fingerprints on the body sections

Styling & Occasion Wear

Worn over a nude or black bodysuit the set reads as an editorial lingerie look suitable for themed photo shoots, burlesque-style performances, or intimate occasions. For a street-facing interpretation, layer the chest section only over a fitted turtleneck with high-waisted trousers, letting the garter straps show below the hem — a pairing popular in avant-garde fashion styling. The all-black colorway with gold hardware also works layered over an all-white mesh top for high-contrast effect.

Sizing & Fit

The harness is designed as one-size-adjustable, with the chest section fitting bust circumferences from approximately 75 cm to 100 cm. The neck collar adjusts from roughly 30 cm to 40 cm neck circumference. Buyers with a bust over 100 cm may find the cross-strap sits higher than intended. The garter and thigh sections fit hip circumferences of approximately 80 cm to 105 cm. All adjustments are made at individual buckle points — there is no single master adjuster, so initial setup takes a few minutes to calibrate all four pieces.

Material & Care

All straps are cut from smooth faux leather (PU-coated polyester) with a consistent 1.5 cm width throughout. The hardware is zinc alloy with a gold-tone plating. There is no fabric lining on the strap backs — the material sits directly on skin. Wipe clean with a damp cloth only; do not submerge in water or machine wash, as sustained moisture will degrade the PU coating at the edges over time. Store flat or loosely rolled to prevent permanent crease marks on the strap surface.