Red Faux Leather Body Harness with X Detail

This red faux leather body harness is built around a structured cage framework with an X-shaped chest detail formed by crossing 1.5 cm wide straps, secured at every junction by silver-tone metal O-rings and rivets. Below the chest, a diamond-grid lattice panel wraps the torso before splitting into four separate garter straps with silver clip hardware at the ends.

Styling and Occasion

Worn over a sheer black bodysuit, the red cage strap pattern creates a layered look suited to festival outfits or themed costume events. For a bolder editorial style, pair it directly over high-waisted wide-leg trousers with the garter straps clipped to hold stocking tops — the silver clips remain visible and function as part of the accessory. The lattice waist section sits neatly under a cropped jacket for a street-style option where only the shoulder straps and garter drops show.

• Costume and themed event styling over bodysuits or corsets
• Festival layering piece over sheer or mesh base garments
• Editorial street look paired with wide-leg trousers and a structured jacket
• Lingerie accessory worn over bralettes with garter straps attached to stockings

Sizing and Fit

The shoulder straps adjust along a 10 cm range via press-stud slots, accommodating bust measurements from approximately 75 cm to 100 cm. The lattice torso panel uses riveted fixed-length straps, so torso length between 38 cm and 48 cm fits without bunching. Wearers with a torso length above 50 cm may find the lower lattice section rides higher than intended — this is an honest fit constraint to check before ordering. The garter strap length is fixed at approximately 22 cm from the lower O-ring to the clip.

• Adjustable shoulder straps with 10 cm adjustment range
• Recommended bust: 75 cm to 100 cm
• Torso length sweet spot: 38 cm to 48 cm
• Fixed garter strap length of approximately 22 cm to clip
• One size construction — not suited for torso lengths above 50 cm

Material and Care

The straps are cut from red faux leather (PU-coated fabric backing), which gives the glossy surface finish visible in the image while keeping the product animal-free. The O-rings and clip hardware are silver-tone zinc alloy, resistant to light surface tarnishing under normal wear conditions. Because PU faux leather does not tolerate heat or submersion, do not machine wash or tumble dry — wipe clean with a damp cloth and allow to air dry flat. Avoid prolonged contact with sharp surfaces that could scratch the PU coating.

• Faux leather straps: PU-coated fabric, glossy red finish
• Hardware: silver-tone zinc alloy O-rings, rivets, and garter clips
• Care: spot clean with damp cloth only — no machine washing
• Storage: hang or lay flat to prevent strap creasing

Strap Configuration

Starting from two shoulder straps, the design crosses at the chest to form the signature X detail, then widens into a horizontal chest band before narrowing into a diamond-grid lattice of six interconnected strap segments across the torso. Each lattice junction is reinforced with a rivet rather than a loose knot, which keeps the grid shape consistent through movement. The four garter straps attach to O-rings at the lower waist band and hang independently, so they can be tucked or removed when not clipping to hosiery.