Red Faux Leather Full Body Harness

This red faux leather full body harness spans from the shoulders down to the thighs in a single connected piece, with silver-tone swivel snap hooks at both shoulder ends and a central chest O-ring that anchors the Y-shaped upper structure. Unlike waist-only styles, the design continues through a horizontal midriff band and a double-band garter section, covering three body zones in one adjustable piece.

Chest and Shoulder Strap Setup

Two wide shoulder straps form a V-shape that meets at a central 3 cm silver O-ring at the chest. Silver swivel snap hooks at each shoulder tip allow the harness to be clipped onto jacket D-rings or worn as a standalone chest accent over a bodysuit or sheer top. Each strap is reinforced with evenly spaced silver rivets along its length.

• Y-shaped upper configuration with two swivel snap hooks at shoulder tips
• Central chest O-ring, approximately 3 cm diameter, silver-tone metal
• Rivet-reinforced red faux leather straps, approximately 2.5 cm wide

Waist and Garter Band Fit

A horizontal waist strap bridges the mid-section with a rectangular silver connector ring at center front, while two metal buckles on the vertical connecting strap let you adjust the torso length between roughly 40 cm and 55 cm. Below the waist, two parallel horizontal bands wrap the upper thigh area and terminate with a small silver D-ring at the lower band. This double-band garter construction stays in place better than a single strap but does add visible layering under tight clothing, so it works best as an over-garment layer.

• Adjustable torso length with two metal roller buckles, range approximately 40-55 cm
• Double horizontal thigh bands for secure garter hold
• Silver D-ring at lower garter band for optional clip-on attachment
• Rectangular silver O-ring at waist center front

Styling and Occasion Ideas

Worn over a black mesh bodysuit with wide-leg trousers and ankle boots, the red straps create sharp color contrast against neutral tones suitable for a night out or a fashion editorial look. For a festival or costume outfit, pair it directly over a red or black crop top, letting the garter bands show below a short skirt. The snap hooks at the shoulders can connect to jacket rings, anchoring the harness for movement-heavy events. Because the design reads as a fashion accessory rather than intimate apparel, it layers cleanly over everyday basics for an avant-garde daytime look as well.

Sizing and Fit Guide

The harness is designed to fit chest circumferences from approximately 80 cm to 100 cm and waist circumferences from approximately 65 cm to 85 cm, adjusted via the two roller buckles on the vertical center strap. The shoulder straps are fixed-length, so wearers with a very short or very long torso (above 60 cm or below 38 cm nape-to-waist) may find the proportions off-center. The garter bands sit at mid-thigh on a 165-175 cm height range; taller wearers may find them sitting higher than expected.

Material and Care

The straps are made from smooth red faux leather (PU-coated fabric backing), which gives a polished, slightly glossy surface without the weight of genuine leather. All metal hardware is silver-tone zinc alloy — the O-rings, D-rings, buckles, and snap hooks are all the same finish for a uniform look. To clean, wipe the straps with a slightly damp cloth and a drop of mild soap, then dry flat away from direct heat; do not submerge in water as prolonged moisture can crack the PU coating at the stitch lines. Store flat or on a hanger to prevent permanent crease marks in the straps.