Strappy O-Ring Faux Leather Body Harness

This red faux leather body harness is built around a geometric strap architecture: shoulder straps feed into a chest panel held by three silver O-ring connectors, then narrow into a waist band and a single central leg loop that anchors the whole silhouette. The straps measure approximately 1.5 cm wide and are cut from smooth, glossy vegan leather that keeps its shape after repeated wear.

Styling for Different Occasions

Worn over a white fitted turtleneck, the red straps create a sharp color-block contrast suitable for a night out or a festival look. For everyday layering, pair it over a longline black tank — the chest O-rings stay visible above a neckline and add visual interest without additional accessories. The leg loop sits comfortably beneath high-waisted trousers when you want a subtle detail, or outside slim-fit jeans for a full statement silhouette. Two concrete combinations: red harness + oversized blazer + straight-leg trousers, or red harness + bodysuit + wide-leg cargo pants.

Sizing and Fit Details

The shoulder and chest straps adjust via silver metal buckles, accommodating a chest circumference range of roughly 75 cm to 100 cm. The waist band adjusts independently, fitting waist measurements from approximately 60 cm to 90 cm. The leg loop is a fixed size and sits around the upper thigh — it fits comfortably on thighs up to approximately 55 cm in circumference. This harness is not recommended for larger thigh measurements as the leg loop does not have additional adjustment points. Sizes on the smaller end of the range will find a snugger fit; sizes on the larger end may find the chest panel sits lower than intended.

• Chest strap range: approximately 75-100 cm
• Waist band range: approximately 60-90 cm
• Leg loop: fixed, suits thighs up to approximately 55 cm
• Strap width: 1.5 cm throughout

Faux Leather Material and Care

The straps are made from polyurethane (PU) faux leather over a woven fabric backing, which gives them enough structure to hold a defined shape on the body without feeling stiff. The silver hardware is zinc alloy — it resists light moisture but should not be submerged. Wipe clean with a slightly damp cloth; do not machine wash, tumble dry, or iron. Avoid prolonged exposure to direct sunlight, which can fade the red pigment over time. Store flat or hung loosely to prevent permanent creasing in the strap material.

• Material: PU faux leather over woven fabric backing
• Hardware: zinc alloy silver-tone O-rings and buckles
• Care: wipe clean with damp cloth only — no machine wash
• Keep away from prolonged sunlight to preserve the red color

Construction and Hardware

Three silver O-ring connectors sit at key junction points — one at the chest center and two at the bust line — distributing tension evenly across the strap network so no single point digs in. A fourth O-ring joins the waist band to the leg loop at the center front. All buckles use a single-prong pin design for straightforward on/off adjustment. There are no snap closures or zippers, so putting on the harness requires threading the shoulder straps over the head first, then fastening the waist buckle.