Studded Faux Leather Harness Set with Garter Straps

This three-piece black faux leather harness set includes a chest harness, waist belt, and thigh garter strap section — all connected by the same narrow faux leather straps and silver-tone stud rivets. Unlike single-piece cage bras, this set layers across three body zones for a structured silhouette that reads as outerwear rather than an accessory add-on.

Chest and Waist Harness Construction

The chest piece runs a horizontal strap across the bust and a single neck strap that meets at the center with a silver O-ring. A secondary horizontal band sits just below the chest, secured by two rectangular silver buckles — one on each side — allowing independent adjustment. The waist belt sits at hip level with a centered silver pin-buckle closure. All strap widths measure approximately 1.5 cm, keeping the profile graphic without adding bulk.

• Silver-tone O-rings at chest center and hip sides, approximately 2 cm diameter
• Two adjustable rectangular buckles on the under-bust band
• Waist belt with single pin-buckle, fits hip circumference roughly 60-90 cm
• Strap width: approximately 1.5 cm throughout all three pieces

Garter Strap Configuration

The lower section wraps around the upper thigh with three parallel horizontal bands and one vertical connector strap on each leg. Silver studs are placed at each junction point, creating a grid pattern across the thigh. The garter piece attaches to the waist belt with a short connector strap. Note that the garter section is designed to sit over other garments or bare skin — it does not attach to stockings or hosiery without additional clips, which are not included.

• Three horizontal bands per thigh, each spaced roughly 3 cm apart
• Silver rivet studs at all strap junctions — approximately 8-10 studs per leg piece
• Vertical connector strap links garter section to waist belt
• Thigh circumference range: approximately 45-60 cm

Styling and Occasion

Over a neutral ribbed bodysuit or nude-tone shorts, the black straps contrast sharply for a layered editorial look suited to festival outfits, themed events, or editorial photo shoots. For a lower-key everyday styling option, wear the chest harness alone over a fitted turtleneck or under an open jacket — the under-bust buckles allow the chest piece to work as a standalone belt over outerwear. The waist belt also functions independently over high-waisted trousers for a minimal harness accent.

Sizing and Fit

The chest harness is adjustable at the under-bust band and the neck strap, fitting bust circumferences from approximately 70 cm to 100 cm. The waist belt fits hip measurements from roughly 60 cm to 90 cm. The garter straps accommodate thigh circumferences between approximately 45 cm and 60 cm. If your thigh measurement is above 58 cm, the horizontal bands may sit closer together and feel tighter — size up is not available in this set, so measure before ordering. All three pieces are connected visually but worn as separate units layered over clothing or lingerie.

Material and Care

Straps are cut from faux leather (PU synthetic) with a smooth, matte-finish surface. Hardware is silver-tone zinc alloy — resistant to light moisture but not suitable for prolonged water contact. Wipe straps clean with a dry or slightly damp cloth; do not submerge, machine wash, or tumble dry. Store flat or hanging to prevent creasing at buckle contact points. The PU material does not stretch, so strap adjustability via the buckles is the only size accommodation.