Tri-Point Harness with Neck Collar and Wrist Cuffs

The Tri-Point Harness with Neck Collar and Wrist Cuffs is a three-component set built around a single central connecting bar: one strap rises to a padded black faux leather neck collar, while two symmetrical diagonal arms terminate in wide, padded wrist cuffs — all joined at a silver chrome O-ring junction. Unlike a full-body cage harness, the tri-point design keeps coverage minimal while the structural geometry creates a strong visual line from neck to wrists.

Collar and Cuff Construction

Each piece in the set uses the same smooth black faux leather with press-stud rivets for a consistent finish. The neck collar measures approximately 3 cm wide with a front O-ring in silver chrome, and the padded wrist cuffs sit at roughly 6 cm wide for a secure, flat wrap around the wrist. The central connector bar keeps the strap length fixed rather than fully adjustable — worth noting if you need variable spacing between collar and cuffs.

• Neck collar: approximately 3 cm wide with front silver O-ring attachment
• Wrist cuffs: approximately 6 cm wide, padded inner surface for comfort
• Central bar: fixed-length vertical strap with bottom junction O-ring in chrome
• All rivets and hardware in silver chrome finish throughout the set
• Connector strap width approximately 2 cm, smooth faux leather exterior

Styling and Occasion Pairings

The tri-point silhouette works as a statement layering piece over a fitted black bodysuit or sheer top — the collar sits flat against the neck while the arm straps create a Y-shape across the chest and forearms. For a festival or editorial look, pair with a cropped jacket left open so the connector strap remains visible; for a lower-key daily fashion accessory effect, wear over a long-sleeve black turtleneck where only the collar shows. The silver hardware reads as jewelry-adjacent rather than strictly costume, which keeps the styling range wider than a full-body harness.

• Over a black bodysuit for an editorial or festival outfit
• Layered on a sheer blouse for a structured collar-and-cuff accent
• Paired with a cropped blazer to frame the central connecting strap

Sizing and Fit Notes

The neck collar is designed to fit neck circumferences of roughly 30 cm to 40 cm, closing with a press-stud buckle at the back. The wrist cuffs accommodate wrist circumferences of approximately 14 cm to 20 cm. Because the connecting bar length is fixed rather than adjustable, the reach from collar to cuffs suits a torso of average proportions; very tall or very short wearers may find the bar-to-collar distance visually off-center. The set is sold as a three-piece unit — collar, connector bar, and both cuffs — and cannot be purchased separately.

Material and Care

The straps and collar band are constructed from smooth black faux leather (PU) over a firm backing layer, giving the set a structured shape that does not droop or stretch during wear. Hardware is zinc-alloy with a silver chrome plating — avoid prolonged moisture exposure to prevent tarnishing. Wipe the faux leather surfaces with a dry or slightly damp cloth; do not submerge in water or use solvent-based cleaners, as these will break down the PU coating over time.

• Faux leather (PU) outer with firm backing — structured, not flexible like fabric
• Silver chrome zinc-alloy O-rings and rivets throughout
• Wipe clean only — no machine wash, no soaking, no solvent cleaners
• Store flat or hanging to prevent strap creasing at connection points