Web Pattern Faux Leather Full Body Harness

This black faux leather full body harness is built around a geometric web pattern on the back panel — multiple straps radiate outward from a central O-ring, forming a symmetrical grid of interlocking angles across the upper back. It is not a simple chest strap; the structure spans from a neck collar down to a waist belt, covering both upper and lower torso in a single connected piece.

Web Strap Structure and Hardware

The back panel is the defining feature: six angled faux leather straps converge at a central black-finish O-ring, creating the geometric web silhouette. Silver-tone metal rivets run along every strap junction, reinforcing seams and adding a sharp industrial contrast to the matte black material. The waist belt terminates in a second O-ring buckle at the front, allowing the harness to sit firmly against the torso without shifting during movement.

• Central back O-ring connects six radiating straps in a web geometry
• Silver metal rivets at every strap crossing point for structural reinforcement
• Neck collar strap sits approximately 1.5 cm wide and lies flat against the throat
• Waist belt with front O-ring buckle for a secure, low-profile closure
• All hardware is matte-finish black and silver-tone metal, not chrome-plated plastic

Styling and Occasion

The back-panel web design is most visible worn over a bare torso or an open jacket. For a festival or club outfit, pair with black leather-look trousers and ankle boots — the harness reads as outerwear, not an undergarment. For a stage or editorial look, layer under a sheer black mesh long-sleeve shirt so the web geometry shows through the fabric. The waist belt sits best at natural waist height, roughly 80-90 cm circumference, and the back panel works on torso lengths from 45 cm to 55 cm shoulder-to-waist.

• Pair with black leather-look trousers for a monochrome club look
• Layer under sheer mesh to show the web pattern as a graphic underlayer
• Works as statement outerwear at festivals, costume events, or photo shoots

Sizing and Fit

The harness is adjustable at the chest, waist, and neck straps via side-release buckles and slider adjusters. The chest panel spans approximately 35-50 cm across (chest circumference 85-110 cm), and the waist belt adjusts from roughly 70 cm to 100 cm. Wearers with a chest wider than 110 cm may find the upper web panel shorter than ideal, as the lateral straps have a fixed maximum extension of approximately 25 cm per side. The neck collar is non-adjustable and sized for an average adult neck of 36-42 cm circumference — wearers with a larger neck should note this before purchasing.

Material and Care

The straps are constructed from matte black faux leather (PU-coated fabric), which holds its shape under tension without cracking at normal temperatures. The material is not perforated or padded, so wearing directly against skin for extended periods may cause light sweating where straps contact the torso. To clean, wipe each strap with a slightly damp cloth and allow to air-dry flat — do not machine wash, submerge in water, or apply heat. Store flat or loosely rolled to prevent permanent kinks in the strap material. Metal hardware should be dried immediately if it gets wet to prevent oxidation.