
Piente
Color
Please select a color
Size
Please select a size
| Care Instructions | Hand wash cool water, mild soap; air dry flat; avoid heat and sharp creasing |
| Lining | Woven fabric backing on all strap sections |
| Closure | Adjustable rectangular gold-tone buckles and rivet-set O-rings |
| Material | PU faux leather over woven textile base; approx 1 cm strap width |
Related Searches
Black faux leather 3-piece set with choker, bra harness, and garter straps joined by gold O-rings.
This 3-piece black faux leather set pairs a choker collar, a strappy bra cage, and a garter belt with thigh bands into one coordinated look. All three pieces share the same 1 cm wide flat faux leather straps and matching gold-tone O-ring hardware, so each component reads as a system rather than a mix-and-match afterthought. The flat strap construction sits flush against the skin, which keeps the silhouette clean when worn over or under sheer layers.
Each piece connects through visible gold-tone O-rings and rivet-reinforced junction points. The choker features a single large O-ring at the throat; the bra cage uses two rectangular gold buckles at the underbust band that allow the chest panel to be tightened or loosened without removing the piece; the garter section has two O-rings at the hip and smaller side rings on each thigh band.
The set works across three distinct contexts. Layered over a fitted white T-shirt or sheer blouse, the black straps create a graphic contrast that reads as outerwear. Worn with high-waisted trousers, only the bra harness and choker show above the waistline — a practical way to wear a single piece from this set on a weeknight out. For a festival or costume look, pair all three pieces over a bodysuit so the garter straps align with the thigh cutouts of an asymmetric skirt.
The adjustable buckles on the bra cage accommodate a chest circumference of approximately 70 cm to 95 cm. The garter belt adjusts at the hip from roughly 68 cm to 98 cm, and the thigh bands fit thighs from approximately 45 cm to 65 cm. The straps are cut from flat faux leather without stretch, so sizing is determined entirely by the buckle range — there is no elastic recovery if the piece is worn at maximum extension. If your measurements fall near the upper limit of any band, the hardware may sit at the last buckle notch, which is a known fit trade-off for this strap-and-buckle style.
The straps are faux leather (PU-coated fabric), chosen for its smooth surface and consistent color across production batches. The backing is a woven textile base. Hardware is zinc alloy with a gold-tone electroplate finish, which resists light moisture but should not be submerged. Hand wash gently in cool water with mild soap; rinse thoroughly and air dry flat away from direct heat. Avoid folding the straps sharply at the buckle tabs, as repeated creasing along the same point can crack the PU coating over time.
Adjustable Faux Leather Harness Bra & Garter Set
$46.35No reviews yet.
You can only review products you have purchased and received.